Smoke Detector vs CO Detector: Do You Need Both in Minnesota?
You need both. A smoke alarm senses fire, and a carbon monoxide (CO) alarm senses an invisible, odorless gas from fuel-burning appliances. They do different jobs and one cannot replace the other. In Minnesota, state law requires a smoke alarm in every dwelling unit and a CO alarm within 10 feet of each room used for sleeping, and combination units are a convenient way to cover both.
Reviewed by John Ihle, MN Master Electrician AM005101 · Three Rivers Electric
What each alarm actually detects
A smoke alarm responds to particles from a fire, usually through an ionization or photoelectric sensor. It will not tell you a furnace is leaking CO. A CO alarm uses a chemical or electrochemical sensor that measures gas over time. It will not warn you about a smoldering couch.
The Minnesota Department of Health lists common CO sources: furnaces, boilers, water heaters, clothes dryers, gas stoves and ovens, fireplaces, wood stoves, vehicles, grills, and generators. It adds that homes with fuel-burning appliances or attached garages are more likely to have CO problems.
Smoke alarm versus CO alarm at a glance
| Feature | Smoke alarm | CO alarm |
|---|---|---|
| Detects | Smoke from fire | Carbon monoxide gas |
| Minnesota requirement | Every dwelling unit | Within 10 feet of each room used for sleeping |
| Typical placement | Inside each bedroom, outside sleeping areas, each level including basements | Near sleeping areas; follow the manufacturer’s instructions |
| Replace after | 10 years | Often 5 to 7 years |
| Low-battery chirp (Kidde) | About every 30 to 40 seconds | Once every 60 seconds |
| End-of-life chirp (Kidde) | Every 30 seconds on sealed models | Every 30 seconds, from seven years after power-up |
What Minnesota requires
Under Minnesota Statutes section 299F.362, every dwelling unit must have a smoke alarm that meets the State Fire Code, and the owner is responsible for maintenance in rental units. The CO law, section 299F.51, requires an approved and operational CO alarm within ten feet of each room lawfully used for sleeping in single-family homes and multifamily units. No one may remove batteries from, or otherwise disable, a required CO alarm.
Cities can add rules. Minneapolis, for example, ties its CO requirement to dwellings with fuel-fired appliances or attached garages, and requires new residential construction to have hardwired, interconnected smoke alarms with battery backup. Always check your city’s inspection office, especially if you are selling, since many Twin Cities cities check alarms at truth-in-housing inspections.
When a combination alarm makes sense
A combination smoke and CO alarm saves a ceiling spot and wiring, and it is often the simplest way to meet both rules in a bedroom hallway. It also has trade-offs.
- Replacement timing differs. CO sensors expire sooner, so you may replace a perfectly good smoke sensor at year 7.
- Placement is a compromise. Smoke rises and CO mixes through the air, so manufacturers’ instructions rule.
- One failure affects both. If the unit fails, you lose both protections until you replace it.
Many homeowners use combination units in hallways and bedrooms and single-purpose smoke alarms on other levels. Either approach can meet the rules when installed per the manufacturer.
Placement tips for furnace season
When the heat comes on, so does the risk of a blocked flue, cracked heat exchanger, or a car warming up in an attached garage. Use these rules of thumb.
- Put a CO alarm within 10 feet of every bedroom door, and consider one on every level, including near the basement mechanical room.
- Keep alarms away from fuel-burning appliances in a way that follows the instructions, so routine start-up does not cause false alarms.
- Do not block alarms with curtains, furniture, or paint.
- Keep smoke alarms out of kitchens and bathrooms where steam and cooking cause false alarms.
- Test everything monthly, and change batteries when the clocks fall back on Sunday, November 1.
If a CO alarm sounds, the Minnesota Department of Health says not to ignore it. If anyone has symptoms, leave immediately and call the fire department. If everyone feels fine, call the gas utility or a qualified technician to find the cause.
Hardwired, plug-in, or battery
CO alarms can be hardwired, plug-in, or battery-powered. Smoke alarms in new construction must be hardwired with battery backup and interconnected, though existing homes are often exempt unless a remodel opens up walls and ceilings. Our guide to hardwired smoke and CO detectors under Minnesota code walks through the options, and the battery replacement guide covers upkeep. Add alarm checks to your annual electrical safety checklist.
Where an electrician helps
We replace old units with interconnected hardwired alarms, add alarms on new levels, and make sure the circuit is sound. Wired alarms should be on a reliable circuit, and mixing brands in an interconnected chain can cause trouble signals. That is where a licensed electrician earns the visit.
Not sure what you are looking at, or want a licensed electrician to handle it? Call 651-418-1476 or request a quote. Three Rivers Electric (MN license EA761814) serves the Twin Cities metro from Saint Paul Park.
Frequently asked questions
Do I need both a smoke detector and a carbon monoxide detector?
Yes. Smoke alarms detect fire, while CO alarms detect an odorless gas from fuel-burning appliances. Minnesota requires smoke alarms in dwelling units and a CO alarm within 10 feet of each sleeping room. A combination unit can meet both needs if installed per the manufacturer’s directions.
Are combination smoke and carbon monoxide detectors good?
They can be. They save wiring and ceiling space and are convenient in bedroom hallways. The downside is that CO sensors expire sooner than smoke sensors, often at 5 to 7 years, so you may replace the whole unit early. Follow the placement instructions on the box.
Where should a CO detector go in a Minnesota home?
Minnesota law requires an operational CO alarm within 10 feet of each room used for sleeping. Many homeowners also add one near the furnace or on each level. Follow the manufacturer’s instructions, and keep alarms clear of obstructions and direct airflow.
How long do smoke and CO detectors last?
Smoke alarms should be replaced after 10 years. Carbon monoxide alarms often last about 5 to 7 years, according to the Minnesota Department of Health. Check the date on the back and replace expired units, even if they still seem to test fine.
Is a CO detector required if I have no gas appliances?
Minnesota’s CO statute applies to single-family and multifamily dwellings generally, with a few exemptions for multifamily buildings that certify no foreseeable CO risk. Local codes may be narrower. Because attached garages and vehicles also produce CO, installing alarms is smart regardless.
Sources
- Minnesota Revisor of Statutes — Minn. Stat. 299F.51, carbon monoxide alarms (2023)
- Minnesota Revisor of Statutes — Minn. Stat. 299F.362, smoke alarms in dwellings
- Minnesota Department of Health — Carbon Monoxide (CO) Poisoning in Your Home
- City of Minneapolis — Carbon Monoxide Detectors and Smoke Alarms
- Kidde — What Causes Consistent Chirping?



